2008 chrysler sebring ac clutch will not disengage even after pulling electrical lead
Is there a ac clutch relay? If so where is it located
Asked by Lonestarit Nov 03, 2015 at 07:30 PM about the 2008 Chrysler Sebring
Question type: Maintenance & Repair
Is there a ac clutch relay? If so where is it located
If it is seized up then either the gap is too small or there is some kind of damage to the clutch. You may need to replace the compressor. If it won't disengage with the wire pulled then it is not an electrical issue.
Is there a ac clutch relay? If so where is it located
2008 Chrysler Sebring
-
Maintenance & Repair
My 2008 chrysler sebring's ac stopped working out of nowhere yesterday. It was always very cold and then just suddenly started to blow warm air noticed the ac clutch is not disengage at all. How ca...
2008 Chrysler Sebring LX Sedan FWD
-
Maintenance & Repair
My Chrysler Sebring LXi will not stay running when engine is cold, but when engine warms up it stays running.
1999 Chrysler Sebring LXi Coupe FWD
-
Maintenance & Repair
I have a Chrysler 2008 Convertible Sebring Touring (2.7 V6 Engine). I recently got my car to start up again (after getting an oil change and a new battery), but I still feel unsafe to drive it. It s...
2008 Chrysler Sebring Touring Convertible FWD
-
Maintenance & Repair
Does my trunk shocks have to work in order to drop the top on my 2008 Chrysler Sebring?
2008 Chrysler Sebring Touring Convertible FWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.