1988 Nissan Pickup won't start
I have a 1988 Nissan 4X4 pickup that is not firing. I just put a new distributor & coil on it
& it still won't start. Any suggestions?
If you have a no spark condition then you need to trace the coil circuit to see where the source of electricity stops. A volt/ohm meter is best for this. If you have voltage at the coil feed side with the ignition on that's good. Next crank the engine and you should see the feed voltage go off and on as you crank. This is because the high voltage coil output to spark plugs happens when the feed circuit current shuts off. The cycle happens in response to the rotation of the distributor. If the current is steady as you crank the engine then I would look at the inductive pick up circuit in the distributor. You basically must have intermittent feed current (battery voltage or sometimes less) at the coil in order to have a spark on the coil output. The coil is key. If steady or no feed current you need to back trace the circuit to find problem. Avoid just changing parts as it could be a simple as a rusted ground connection in the wiring harness. Probably a good idea to clean every ground connection you can find in the engine bay for a vehicle that old. Good luck!
Is it giving plenty of spark now? If so, you have a fuel issue. Have you checked to see if your fuel pump is humming when the key is turned to accessory? Have you checked all your fuses and relays? What have you done besides putting in a new dist and coil?
It's getting fuel. I can hear the fuel pump humming. Getting ready to check the fuses & relays. The new coil & distributor is the where I'm starting from. Thank you.
Did you put in a distributor or replace the cap?
I put in a new distributor
And a new coil
Double check timing and no. 1 lines up with TDC on the compression stroke. Distributors are easy to put in wrong. Even one tooth off can make a difference.
A distributor out of phase will certainly cause a no start condition too, as mentioned by Bvcxz6789, I assumed that you changed the distributor because it would not start, but if it ran before you changed the distributor make sure the distributor is phased correctly. It is more than just lining up the rotor with number one plug wire at TDC; you must make sure number one cylinder is on the compression stroke when rotor is phased to number one wire on dist. cap. Still, if you are not getting a spark while cranking engine it doesn't matter if the distr. is out of phase as spark should and must be present.
I have a 89 Nissan d21 hardbody 5 speed with the 2.4 liter in it. I just replaced my battery thinking it was bad bc of very poor to zero power over night. My dash lights come on all the lights work but barely and the blinkers quit completely. What could it be causing my battery to drain over night?
Check your ground connections. Even if tight there could be corrosion at the terminal to ground connection or even right at the battery posts. Also check for heat by touch at critical electrical connection points. You will not get electrocuted from 12 volts, but bad connections may give off heat from resistance and help to find the source of the barrier blocking the battery output.
I have a 87 pathfinder was driving fine the person I bought it from came over and I went to go to the store after he left now it won't start plz help
I have a 1990 nissan hardbody 4x4 SE. I drove it an parket it an went to crank it.. it want start..... good power... I got fuel I got fire..... wat else could it be... vg30e engine gen 1.
Looking for a Used Pickup in your area?
CarGurus has thousands of nationwide listings and the tools to find you a great deal.
Search Nissan Pickup Questions
Nissan Pickup Experts
Find great deals from top-rated dealersSearch
Related Models For Sale