ignition switch too long for rod?

25

Asked by Blaze Jun 12, 2007 at 01:39 PM about the 1977 Jeep Cherokee

Question type: Maintenance & Repair

the ignition switch for the 77 is too long it binds up so tight you cant turn the key. I have used both tilt and notilt switchs and still cant fix it. What am i doing wrong?

505

alittle answered 16 years ago

Did you try adjusting the hold-down screws that mount the ign switch? They're slotted, you know! Make sure that the top of the rod is fitted properly in to the rack at the top side of the column and hasn't popped out of the slide on the rack. Best way I found to adjust them is to place ignition lock into ACC position which is all the way up, Pull down on ign switch, tighten up switch, turn key to on and then to DETENT or Start position, if engine starter engages you have it right, if not, move ign switch up slightly until it engages and lock it down.

Mark helpful

Your Answer:

ignition switch too long for rod? 1 Answer

the ignition switch for the 77 is too long it binds up so tight you cant turn the key. I have used both tilt and notilt switchs and still cant fix it. What am i doing wrong?

1977 Jeep Cherokee

-

Maintenance & Repair
if the actuator rod is binding the lock cylinder up because of the ignition switch on a 77 cherokee chief what do i do ? 1 Answer

the lock cylinder was seiezed on the column so i replaced it and now the rod that goes into the ignition switch when installed is so tight you cant turn the key. I've put 3 different switches on and t...

1977 Jeep Cherokee

-

Maintenance & Repair
Spark from power wire under ignition switch 4 Answers

I got a 95 jepp cherokee country. They rigged the starter to a button under the switch so it still works. The fuel pump is good i ran a wire to the battery to check it. Turned key. Heard it work. O...

1995 Jeep Cherokee Country 4-Door RWD

-

Maintenance & Repair
Cost of replacement for ignition tumbler 1 Answer

Cost to replace ignition tumbler

2000 Jeep Cherokee Sport 4-Door RWD

-

Maintenance & Repair
1995 Jeep Cherokee OverheatingHello all,Got a slight over-heating problem with my Jeep. Actually I noticed this from about 2 years ago and it's still the same today.When I'm stuck in bad traffic, or sit at a red light for too long, the temperature gauge would slowly creep upwards over the middle marker toward the third marker. I have not had it sitting idle for so long that it went into the last red region.But as soon as I start driving again, the temperature drops back down below just under the halfway mark.To me it sounds like an airflow problem, i.e. the engine is not getting enough airflow when it's sitting idle.Could this be the fan? Or a clogged or dirty radiator?I see two fans. The fan on the right always spins. The fan on the left does not spin when the engine is started. Are they both suppose to spin?Thanks in advance for any advice.Regards, 2 Answers

Hello all, Got a slight over-heating problem with my Jeep. Actually I noticed this from about 2 years ago and it's still the same today. When I'm stuck in bad traffic, or sit at a red light for too ...

1995 Jeep Cherokee Sport 4-Door 4WD

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.