1987 ford crown Victoria will not go into reverse ?

Asked by Apr 13, 2018 at 01:41 PM about the 1986 Ford Crown Victoria

Question type: Maintenance & Repair

1 Answer

7,250

The most likely cause is that the piston seals have failed and no pressure is available to squeeze the clutch reverse clutch. This is an internal problem and transmission must be removed to repair it. The car is over 20 years old, you don't say how many miles are in the vehicle, but I would say it is time for the transmission start showing signs of wear. When you put it in reverse, does it try to move at all?

Your Answer:

Ford Crown Victoria Experts

  • #1
    Tracy Hooks
    Reputation
    2,420
  • #2
    Bob Beaman
    Reputation
    1,230
  • #3
    tennisshoes
    Reputation
    1,020
View All

Related Models For Sale

Used Dodge Charger
41 Great Deals out of 929 listings starting at $4,995
Used Lincoln Town Car
10 listings starting at $5,995
Used Ford Taurus
23 Great Deals out of 381 listings starting at $4,500
Used Ford Mustang
28 Great Deals out of 1,786 listings starting at $4,800
Used Chevrolet Impala
37 Great Deals out of 1,008 listings starting at $2,995
Used Ford F-150
135 Great Deals out of 10,340 listings starting at $2,000
Used Chevrolet Camaro
8 Great Deals out of 1,058 listings starting at $10,995
Used Toyota Camry
35 Great Deals out of 1,637 listings starting at $1,995
Used Honda Accord
26 Great Deals out of 1,740 listings starting at $1,995
Used Honda Civic
88 Great Deals out of 5,929 listings starting at $3,695

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.