we have fixed our Rodeo, by replacing the slave cylinder and the master cylinder then we went to try to bleed the clutch and for some unknown reason it has no pressure we have tried every thing.

Asked by micheleandtoby Sep 12, 2013 at 07:36 PM about the 1992 Isuzu Rodeo

Question type: Maintenance & Repair

I was told to replace the master cylinder about a year ago but have been having trouble putting it into gear. so then i was told to bleed the clutch and so i did, but with no success as a matter of fact the pedle went all the way to the floor and will not regain pressure it wont even come back up. so I was told that i would need to replce the slave cylinder and then bleed if. So I did, with no success. What do I do now?

199,735

dandyoun answered 10 years ago

Had one of about the same age do the same. I had to bleed system several times. When pedal stayed on the floor I would pull it back up and repeat the process. Make sure you keep resivoir full and pedal fully depressed until bleeder is tightened back. After several times of the repeated process it started acting like it should. It's been over two years since then and its still going strong with no further issues.

6 people found this helpful.

Mark helpful

Your Answer:

we have fixed our Rodeo, by replacing the slave cylinder and the master cylinder then we went to try to bleed the clutch and for some unknown reason it has no pressure we have tried every thing. 1 Answer

I was told to replace the master cylinder about a year ago but have been having trouble putting it into gear. so then i was told to bleed the clutch and so i did, but with no success as a matter of fa...

1992 Isuzu Rodeo

-

Maintenance & Repair
why is my 1994 rodeo having issues with clutch after replacing master cylinder and clutch slave? 2 Answers

The brake is also harder than usual and feels like it has air now. after changing the slave it would not crank. so we changed clutch master cylinder and it turns over to this grinding noise. I ha...

Isuzu Rodeo

-

Maintenance & Repair
My rodeo has this problem when I'm driving along all of a sudden it like it looses power and slows down a bit and then it speeds up and back fires a couple of times and then drives normal again 2 Answers

I have owned the rodeo for almost a year and have replaced different thing like fuel filter fuel injectors and different thing now someone said replace the fuel pump but I thought when the fuel p...

2002 Isuzu Rodeo LS

-

Maintenance & Repair
When I start my car, and put it in drive or reverse, I have to use a lot of break or the car will go much too quick. 2 Answers

Also, when first starting I can let the car just 'roll' with no gas or breaks and the car will maintain its speed pretty good.

2002 Isuzu Rodeo S V6

-

Maintenance & Repair
Is there an alternate repair solution for the codes p0355, p0452,p0453 and p0463 than replacing the entire system of my V-6 1998 Izusu Rodeo passport 6 Answers

The warning for fuel (gasoline) on my 1998 Isuzu Rodeo Passport is the car does not move and the OBD II codes given me ar p0355, p0452, p0453,and p0463. I'm told to replace the entire wiring for the c...

1998 Isuzu Rodeo

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.