no spark nd power

Asked by Dec 13, 2017 at 09:40 AM about the 2007 Ford Bantam

Question type: Maintenance & Repair

I changed my computer box nd key ..she's got no
spark nd power by the instruments. .please help

4 Answers

I got no spark nd power by my cluster ..


Have you got the correct Computor Box for your Bantam ? We repair these units. The keys have to be programmed to the Key reader and the reader is then coded to the PCM (Computor Box) . If the engine is cranking , but no spark, Check the starter relay, its possibly got a short circuit in it. This relay needs to be replaced. Sounds very much like your PCM needs repair. Check the condition of all of the fuses and relays. Is there water coming into the passenger compartment from the main wiring harness on the left side under the dash ?

Where is the computer box in the Rocam 2006 1.3i?


The Computer Box is located on the left side A Pillar under the dash. To remove the Computer Box, remove the passenger side door kick panel which has three plastic clips or screws and then remove the panel under the dash. Drill the rivets that are securing the lower section of the Computer Box. The harness just un clips.

Your Answer:


Looking for a Used Bantam in your area?

CarGurus has thousands of nationwide listings and the tools to find you a great deal.

Postal Code:


Ford Bantam Experts

  • #1
  • #2
    Janus Welgemoed
  • #3
    AB Zaviour
View All

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.