Ford bantam rocam 2010

Asked by GuruFTFZ2 Apr 19, 2020 at 08:03 AM about the Ford Bantam

Question type: Maintenance & Repair

Hi everyone can you please assist
On my Ford bantam 1.3 rocam, I was changing the
spark plugs yesterday when we done with
changing the spark plugs we attempt to start,it
didn't start but the engine is cranking and before
changing the spark plugs it was running smoothly
and on dash cluster it only show handbrake lights
when it is on and it is pumping the fuel, I have
check all relays and fuses they still fine.

2 Answers
16,465

Guru97FK8 answered 4 years ago

The spark plugs on this model have to be set to 1.3mm gap. Check the fuses and the relays. Check for fault codes in the system.

Mark helpful
16,465

Guru97FK8 answered 4 years ago

Check the starter selonoid wire if its running in the same channel as the crank position sensor wiring. If they are running together, separate them. High voltage current on cranking induces' current in the low voltage crank sensor wires, preventing the engine from firing up and starting.

Mark helpful

Your Answer:

Related Questions

  • Ford bantam rocam 2010 2 Answers

    Hi everyone can you please assist On my Ford bantam 1.3 rocam, I was changing the spark plugs yesterday when we done with changing the spark plugs we attempt to start,it didn't start but the engine...

    Ford Bantam

    -

    Maintenance & Repair

  • ford bantam 2010 1.3 rocam 3 Answers

    my ford bantam cuts as if its a petrol but still start and moves but it cuts at some point

    Ford Bantam

    -

    Maintenance & Repair

  • Ford bantam rocam 3 Answers

    Hi, I have a Ford bantam rocam not starting , fuel and spark is the, and the cranking is too weak, charged the battery but still the same, push the car but still no difference, and when you crank ...

    Ford Bantam

    -

    Maintenance & Repair

  • FORD BANTAM XLT ROCAM 3 Answers

    MI BANTAM HAS A FLAT SPOT IF I PULL AWAY AFTER I WENT OVER A HUMP, OR IF I WANT TO PASS A NOTHER VEHICLE OR IF I SLOW DONW AT A HEALT SIGHN AND PULL AWAY MOSTLY IN 2ND GEAR AND 3RD GEAR SOME TIMES ...

    Ford Bantam

    -

    Maintenance & Repair

  • Ford bantam Rocam 1.3 3 Answers

    My ford bantam shows that the cluster is not working I fitted a new battery bt now the gurges are not working, is there anything I could try before I replace the cluster? coz m worried I may buy a ...

    Ford Bantam

    -

    Maintenance & Repair

Shortcuts

Search Ford Bantam Questions

CarGurus Experts

  • #1
    Guru97FK8
    Reputation
    15,160
  • #2
    Janus Welgemoed
    Reputation
    1,140
  • #3
    MrRocket12
    Reputation
    1,120
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.