Ford bantam rocam
Hi, I have a Ford bantam rocam not starting ,
fuel and spark is the, and the cranking is too
weak, charged the battery but still the same,
push the car but still no difference, and
when you crank for a long time the plug gets
wet , what could be the fault? I really need
When cranking the engine, the computer box registers a minimum cranking speed thresh hold. A minimun cranking speed is normally about 250 RPM. Below that there will be no spark or injection. If the engine is flooded, Put wide open throttle and then crank the engine. By having wide open throttle the injectors will switch off and should allow the engine to start. Check also for the starter cranking speed.
Thanks I will do that tomorrow morning, I will give you the feed back after I'm done
I had the exact same problem. The mechanic told me there is a break in the loom.Never had this problem before.Just after I really ran out of fuel half a meter from the pump.Stupid I know. The next morning my oil light starting appearing if I drive under 3000rpm and when I got on the highway I just heard this moerse rattling sound from the engine and the motor switched off.After, waiting for I few mins I got the motor cranked ,but sounded dry like sand is inside it.(think I bend a valve)
Looking for a Used Bantam in your area?
CarGurus has thousands of nationwide listings and the tools to find you a great deal.
Search Ford Bantam Questions
Ford Bantam Experts
Find great deals from top-rated dealersTMSearch