engine will not start

Asked by Jul 15, 2017 at 08:38 AM about the 2006 Ford Bantam

Question type: Maintenance & Repair

4 Answers

257,925

Darn, so can you give us some details/symptoms to go on?

1 of 1 people found this helpful.
165

Is the engine not cranking or cranking and not firing up ?

1 of 1 people found this helpful.
165

If the engine does not crank, check the PATS LED (Immobilizer warning light) next to the clock. This light on switching the ignition to ON will illuminate for a few seconds then go out. If it flashes quickly and the flashes up a code, or stays ON all the time, it's a PCM (Computer Box) problem. These can be repaired. If you dropped the vehicle key the transponder in the key will break and will have to be replaced. As I have said, these Computer Boxes can be repaired and it's done in the Pretoria area. (Phone 0820606425)

165

If the engine cranks and there is no spark, check the starter relay. If the starter relay has a short circuit , the engine will crank but there will be no spark at the plugs. If there is no fuel at the injectors, check the impact switch on the left side A pillar under the dash. There is a hole in the side cover. Put your finger through this hole and press the button in. This switch disables the fuel pump.

Your Answer

Bantam

Looking for a Used Bantam in your area?

CarGurus has thousands of nationwide listings and the tools to find you a great deal.

Postal Code:

Shortcuts

Ford Bantam Experts

  • #1
    Janus Welgemoed
    Reputation
    620
  • #2
    Joel Mearns
    Reputation
    560
  • #3
    MrRocket12
    Reputation
    470
View All

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.