Knock sensor ford bantam

Asked by Aug 10, 2019 at 02:50 PM about the 2006 Ford Bantam

Question type: Maintenance & Repair

Hi I'm putting a spitronics PCM
management on my 1.3 ford bantam
rocam. The diagram requirements is
tdc sensor power, tdc sensor signal.  
Do I connect it to my knock sensor or
do I go for the cam sensor. And then
trigger sensor signal, trigger sensor
power. Is these two going to ignition
coil or to the injectors...?

1 Answer

4,185

Pre 2007 the crank angle sensor requires a flywheel with 36 minus 1 tooth on the flywheel and the 2007 onwards requires a requires a flywheel with 36 minus 2 teeth. Both 1300s, new and old have knock sensors.

Your Answer:

Shortcuts

Ford Bantam Experts

  • #1
    Guru97FK8
    Reputation
    3,670
  • #2
    Janus Welgemoed
    Reputation
    940
  • #3
    AB Zaviour
    Reputation
    820
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.