I have a ford bantam 2002 i cant seem to get my braks fuction right every time i bleed them thay just go back to no brakes and while driving i have to pump them to be able to break for a few seconds

10

Asked by dyllen96 Jul 30, 2015 at 03:43 AM about the Ford Bantam

Question type: Maintenance & Repair

Ive replaced master celinder brake
pads brake discs and fleud please
help

11 Answers

9,755

Its sucking air somewhere, clean all the pipes and cylinders and check were it leaks.

2 people found this helpful.
Best Answer Mark helpful
64,500

Did you bleed the master cylinder before installing on vehicle ?

3 people found this helpful.
64,500

Was you having this problem of no brakes before or after installing master cylinder and brake pads ?

2 people found this helpful.
10

Yes but caant seem to get the working its as if the system cant hold presure and there is no fluied leaks

64,500

Did you have any brake work done? Replace calipers, brake pads etc .

1 people found this helpful.
64,500

You have what did a front and rear brake job and what's on the rear shoes or pads ?

1 people found this helpful.
10

Hi, I have similar issue, only mine started after replacing the master cylinder, brake pads was replaced in February 2016, Master cylinder was replaced in June 2016

1 people found this helpful.

Your Answer:

Bantam

Looking for a Used Bantam in your area?

CarGurus has thousands of nationwide listings and the tools to find you a great deal.

Postal Code:

CarGurus Experts

  • #1
    Guru97FK8
    Reputation
    15,140
  • #2
    Janus Welgemoed
    Reputation
    1,140
  • #3
    MrRocket12
    Reputation
    1,120
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.