Front Spindle removal off of the hub..

Asked by jvhunt007 Feb 26, 2011 at 11:16 AM about the 1980 Jeep CJ-5

Question type: Maintenance & Repair

I have a 1980 CJ 5 and I am trying to get the spindle off of the hub on the front end.  I have the locks off and brakes off this is my next step as I am removing the front axles to replace the universals . Any Ideas?  I do not believe this has been apart before ? Please any help would be appreciated... Thanks Jim

1 Answer

205

I'm assuming it's a dana 30 front with disc brakes. So remove tire/wheel, brake calipers and pads, lockout/hub assembly, spindle nuts and bearings, then there will be 6 9/16ths nuts that hold the backing plate and spindle on, remove them pull backing plate off, use a small chisel in between the spindle and knuckle to help seperate. Once you get the spindle off then the shaft will slide right out.

3 people found this helpful.

Your Answer:

CarGurus Experts

  • #1
    Michael Harrison
    Reputation
    140
  • #2
    Murray James
    Reputation
    110
  • #3
    Neil Connolly
    Reputation
    100
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Jeep CJ-7
1 listing
Used Jeep Cherokee
92 Great Deals out of 1,952 listings starting at $6,399
Used Jeep Wagoneer
1 listing
Used Ford F-150
363 Great Deals out of 12,802 listings starting at $599

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.