Timing

Timing 1 Answer

How you set the timing? Can't seem to find the line it's supposed to be at? Also how do you use the inductive timing light? I know the setting its supposed to be at but I just don't know how to get...

I have a 351 Cleveland engine that just wants to backfire through the carb. Checked timing and it appears to be accurate. The intake is a performer with a Holley carb, I think it's a 4160, but I just can't seem to make it sit, the intake, on the engine, without sealing properly. I've tried to seal the intake with black rtv at then ends of the intake won't seal. Replaced the intake gaskets with edlebrock gaskets and didn't use valley pan gasket, still can't get her to seal. It's leaking along the rear, right side intake matting service. I'm lost at what else to do. Help! 2 Answers

351c with a performer intake. Pop's on accel. Checked timing, it seems ok. I just can't get the intake to seal properly. No valley pan gasket,black rtv on the ends of the intake and using edlebrocks i...

fuel pump problems 1 Answer

1979 Ranchero Gt, 351M. Changed out electric fuel pump. Went back to mechanical, had to use a fuel filter and a rubber gas line.(pump to carb) The metal hose was gone. Starts and idles fine, but a ver...

1970 ranchero. Would upper ball joints cause a clunking sound when stopping? I did check tie rods,centerlink,idler, and lower ball joint. But I don't know how to check the upper joint. I had to stop yesterday,6-29-13, because it's just to darn hot out here. I bought this car for my son but now I realize I don't know what I'm doing. My wife informs me of that,lol. 2 Answers

Most of the front end parts are pretty tight. But I gave up on checking the upper ball joint because it just got 106 outside yesterday and I'm not sure how to check it for wear.

I have a 78 ford ranchero 500survivor series. What amp of glass fuse do I need?125 or 250? ....and is that for my breaks? I don't have a diagram. Thank you. 4 Answers