Crank shaft sensor bracket holder

Asked by Guru9D44D Jun 03, 2017 at 07:27 AM about the 2004 Opel Corsa

Question type: Maintenance & Repair

Where does a crankshaft sensor bracket
holds, does it hold on the water pump of
block?

2 Answers

220,505

Not sure exactly but it would be very specific where it goes as the crankshaft sensor is precisely placed into the block. More than likely it bolts to the block. Just put it up there with the crankshaft sensor in place to find the bolt holes.

1 people found this helpful.
16,315

The Crank Angle Sensor is located on these engines near the crankshaft pulley at the front of the engine. The bracket is possibly mounted on through a cover onto the engine block.

1 people found this helpful.

Your Answer:

CarGurus Experts

  • #1
    Clifford Netshilonwe
    Reputation
    3,690
  • #2
    Somila Manqupu
    Reputation
    2,580
  • #2
    GuruDXPQG
    Reputation
    2,580
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.